Best part of being a bench jeweler is that you can wear your work. Tell me of a history student that normally would wear their project on a ring??
One of the toughest things is keeping your work in good condition. Whether it be keeping brass jewelry polished without oxidizing, or resisting to wear your sterling silver ring because you feel guilty about the scratches!
The Wu-tang ring I cut out of brass and soldered in 3 spots, it is a two finger ring!
My 3-D triple tube setting Brass ring can be seen on the left at an angle,
My second lost-was cast sterling silver ring with orange cubic-zarconia on the bottom.
Also there is a spinning sterling silver band with flush set opals (I did not make this ring) I purchased this at TJ Maxx, surprisingly.
I would love to make a spinning band! Any suggestions?
No comments:
Post a Comment